Love car travel, will inevitably go wrong, especially in the event of an emergency when the car suddenly caught fire, a series of attempts have not responded, only to find that the original battery was not caused by electricity, it is about to delay major events, what should we do in the end? Don't worry, today Xiaobian is for your rescue, remember the following points, you don't have to worry about the car is out of power.

　　一、推車啟動

　　I. Launching of carts

　　這是一種不得己的手腕，不能經常運用，這個需求察看車輛所在的位置，假如是下坡能夠借此進步車速，假如是上坡這種辦法使不得，車速也很難進步，應該調轉車頭向下坡方向推車。盡量不要在車輛和行人多的路段推車起動，以免車輛起動后駕駛者應變不當呈現不測。

　　This is a kind of unavoidable wrist, which can not be used frequently. This demand inspects the location of the vehicle. If downhill can improve the speed of the vehicle by this way, if uphill is unavoidable, the speed of the vehicle is also difficult to improve. We should turn the head to push the vehicle downhill. As far as possible, don't start the cart in the section with many vehicles and pedestrians, in order to avoid the driver's inappropriate response after the vehicle starts.

　　車輛推進之前應翻開點火開關，到達相當車速后，將變速器掛入擋位，然后疾速松開離合器踏板并加油。引擎一旦起動，應疾速踩下離合器踏板，樣做對發起機和離合器有一定的損傷，自動擋車輛特別要防止運用此辦法起動。推車起動普通需求兩個人以上，假如只要司機一人就難以施行起動同時控制油門，不讓發起機熄火，然后漸漸停車。

　　The ignition switch should be turned on before the vehicle is propelled. After reaching a comparable speed, the transmission should be put in gear, and then the clutch pedal should be quickly loosened and refueled. Once the engine is started, the clutch pedal should be stepped down quickly, which will cause some damage to the generator and clutch. In particular, auto-stop vehicles should be prevented from starting by this method. The ordinary demand for starting a cart is more than two people. If only one driver can't start and control the throttle at the same time, don't let the engine stall, and then stop gradually.

　　二、搭接啟動

　　2. Overlap Start

　　假如遇到狀況時還有同行的車，車上還有跨接電纜時，還能夠采用電瓶搭接的辦法啟動車輛。詳細操作時先將兩輛車靠近，直到跨接電纜足夠銜接兩塊蓄電池的正負極。要留意確保兩輛車沒有接觸，只允許運用具有足夠的承載才能且?guī)Ы^緣外皮的電纜。假如提供電源的蓄電池在車輛上的裝置位置不便當直接停止跨接，則必需運用工具將蓄電池拆下。

　　If there is a peer car in case of a situation, and when there is a straddle cable on the car, the battery lapping method can also be used to start the vehicle. Detailed operation will be carried out by approaching the two vehicles until the cross cable is sufficient to connect the positive and negative electrodes of the two batteries. Care should be taken to ensure that the two vehicles are not in contact and that only cable with sufficient carrying capacity and insulated skin is allowed to be used. If the position of the battery on the vehicle is inconvenient, the battery must be removed by means of tools.

　　關閉車上一切隸屬用電設備，啟動提供電源的蓄電池所在的車輛，使其發起機運轉幾分鐘以保證電量充足。然后按正常方式起動無電車輛，起動后應輕踩加速踏板，使發起機以2000r/min的轉速運轉幾分鐘。然后關閉兩輛車的點火開

　　Turn off all subordinate electrical equipment on the vehicle and start the vehicle where the batteries provide power. Make the starter run for a few minutes to ensure sufficient power. Then start the non-electric vehicle in the normal way. After starting, the accelerator pedal should be slightly pressed to make the engine run at the speed of 2000 r/min for several minutes. Then turn off the ignition of the two cars and turn on

　　關，當心撤除電纜，留意防止正負極電纜接頭相碰。

　　Close, take care to remove the cable, pay attention to prevent the cathode and cathode cable joint collision.

　　溫馨提示：汽車沒電再放一會也不會有電,而且電量只會越來越少;萬一車徹底沒電了，您好還是呼叫救援，讓修理廠的人過來拖車吧！

　　Warm Tip: The car will not be able to run without electricity for a while, and the electricity will only be less and less; in case the car is completely out of power, you'd better call for rescue and let the repairman come over to the trailer bar!